Solution

Chemical Powder Handling

Chemical plants move pigments, resins, fluorochemicals and additives between floors and packing formats. Routes must handle abrasion, stickiness and dust while keeping operators away from open transfer.

Request a Quote Browse equipment

What the system covers

Intake, vertical or horizontal transfer, storage, dosing, packing and dust control, engineered as one route. Because chemical powders vary widely in abrasiveness and flow behaviour, equipment is chosen per material rather than from a fixed catalogue.

Wear and material selection

Abrasive pigments and fillers can wear through thin-wall pipe quickly, so routes are specified with ceramic-lined bends, thicker wall sections or dense-phase transfer at lower velocity. Sticky products use larger outlets, agitation and air-assisted discharge.

Safety and housekeeping

Transfers are enclosed and extracted at every open point, with pulse-cleaned filters and sealed ash discharge. Manual handling of drums and open buckets is replaced by vacuum or pneumatic conveying wherever the layout allows.